Assembling the Pump

If you are a first-time user, we recommend that you read these steps of assembling the pump till the end. It is also advisable to watch the assembling video.

In each package, you will find:

  • 1 Pumping Bra
  • 2 Bottles
  • 2 Connectors
  • 2 Breast Shield
  • 2 Silicon massage insert
  • 2+2 Duckbill valve
  • 2 Silicon Diaphragm
  • 2 Cylinder cover
  • 1 Double pumping tube which is recommended
  • 1 Single pumping tube
  • 1 Adapter
  • 1 Rechargeable lithium ion battery (last 3 hours once fully charged)
  • 1 Motor unit
  1. If you want to make the pump portable, use the rechargeable battery, otherwise you can use the AC adapter. AC adapter can also be used in case the battery is not charged.
  2. If you have decided to use the battery, then start with inserting battery into the motor unit by matching it with the golden conductor. Keep a part of the pink string outside so that you can remove the battery easily.
  3. In case, you forget to keep the pink string out, you can still remove the battery. Watch the assembling video to learn how to do this.
  1. Attach the silicon massager insert with the breast shield.
  2. Tightly fasten the duckbill valve with both the connectors. There are 2 extra duckbill valves which can be used in case any of the duckbill valve is lost or spoilt.
  3. Put the silicon diaphragm at the top of the connector and then put the cylinder cover on it.
  4. Attach the bottle with each connector.
  1. Now connect the double pumping tube with the long side of the pump and insert the two-way small tube into the hole of the cylinder cover.
  2. Ensure that the tube is connected from the end opposite to the arrow.
  3. The tube has 4 openings at the centre, the side opposite the arrow should be connected to the motor and the right and left should be connected to each cylinder cover. The one which has an arrow should be left as is.
  4. Note that you should use the double tube only if you are pumping double side. If you are doing single side pumping, then use only the single tube which doesn’t have the white coloured centre.
  1. When the motor is switched on, the silicon diaphragm should start moving up and down. If not, please ensure that you have assembled correctly.
  2. Now, wear the pumping bra and adjust it according to your size.
  3. If you are using the pump for the first time or after a long gap, massage the breast with warm water and dry it before using the pump.
  4. Place the breast shield around the nipples.
  5. Attach the container with the breast shield. Now it is ready to use.
  6. You can sit or stand as per your preference.
  1. There are three modes. Stimulation mode, Expression mode and Power Expression mode.
  2. Press the ON/OFF button.
  3. Stimulation mode will start with purple light.
  4. After 1 to 2 minutes, press the switch button to change to the recommended expression mode for deep suction. You will see the colour change to red.
  5. For power expression mode, press the switch button again and the blue light will turn on.
  6. You can control the suction level from the pump, by pressing the increase or decrease button.
  7. You can change the mode anytime by pressing the switch button.
  8. You can press pause button to pause the machine.
  9. When you are finished, press the ON/OFF button to off the motor unit.
  1. Once you are done, dissemble all the parts and wash them properly in warm-soapy water for next use except for the tubes, motor unit, battery and AC adapter.